Taurus Alpatec TORONTO P Mode D'emploi page 13

ASSEMBLING THE STONES:
- The appliance has two finishes, charcoal or
stone.
- If you want to finish the stone, see the instruc-
tions (Fig.1).
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
- To eliminate the smell given off by the appliance
when used for the first time, it is recommend-
ed to have it on at full power for 2 hours in a
well-ventilated room.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch
(B).
- Turn the appliance on, by using the on/off button
(a) or (I). This button activates / deactivates all
functions of the control panel, the remote control
and the effect of the flame.
- The screen goes off after 30 seconds without
pressing any button. To turn on the screen press
the on/off button again.
HEAT INTENSITY
- Press the (d) or (II) button to select the heating
power.
- Press +/- to select the temperature desired for
each power (from 15 to 30ºC).
- There are 3 positions: low power, high power
and off.
FLAME INTENSITY
- Press the (f) or (IV) button to select the flame
intensity.
- Every time the button pressed, the flame inten-
sity change. There are 5 levels to choose.
TIME SET UP THROUGH THE CONTROL
PANEL
- Press (e) button to adjust the hour.
- Press +/- to set up the hour.
- Press (e) button again to adjust the minutes.
- Press +/- to set up the minutes.
- Press (e) button again to adjust the days.
- Press +/- to set up the days.
TIME SET UP THROUGH THE REMOTE CON-
TROL
- Press (VII) button to adjust the hour.
- Press +/- to set up the hour.
- Press (X) button to adjust the minutes.
- Press +/- to set up the minutes.
- Press (V) button to adjust the days.
- Press +/- to set up the days.
WEEKLY PROGRAM SET UP
- Press (VIII) button to start with the weekly
program set up.
- Press (IX) button to select ON mode (to set up
when the appliance will turn on).
- Press +/- to set up the day of the week.
- Press the (VII) button and then press +/- to
adjust the hour.
- Press the (X) button and then press +/- to adjust
the minutes.
- Press the (IX) to select OFF mode (to set up
when the appliance will turn off).
- Repeat the same actions for all days of the
week.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off button.
- Turn the appliance off using the on/off switch.
- Unplug the appliance from the mains.
- Clean the appliance.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and off
repeatedly, for reasons other than the ther-
mostat control, check to ensure that there are
no obstacles that impede correct air entry or
expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.