Product Assembly - cecotec FORCECLIMA 7050 Manuel D'instructions

3. PRODUCT ASSEMBLY

WARNING: before using the mobile local air conditioner, keep it upright for at least two hours.
The local air conditioner can be easily moved in the room. While moving it, make sure that
the local air conditioner is in the upright position and always place it on a flat surface. Do not
install and use the local air conditioner in the bathroom or other humid environments.
• Install the heat pipe assembly (as shown in Fig.1): screw the
heat pipe assembly (exhaust fitting end) into the exhaust port
on the rear panel.
• Install the window-sealing plate assembly:
- Half open the window, and mount the window-sealing
plate assembly to the window (as shown in Fig.2 and
Fig.3); the assembly can be placed in horizontal and
vertical direction.
- Pull various components of the window-sealing plate
assembly open, adjust their opening distance to bring
both ends of the assembly into contact with the window
frame, and fix various components of the assembly.
• Install the body:
- Move the machine with installed heat pipe and fittings before the window, and the
distance between the body and walls or other objects shall be at least 50 cm (as
shown in Fig.4).
- Elongate the exhaust pipe and put together the flat end of the exhaust pipe joints
into the hole of the window-sealing plate assembly (as shown in Fig.5 and Fig.6).
NOTES: the flat end of the exhaust pipe joints must be fitted into place. The pipe cannot be
distorted or excessively turned (greater than 45°). Keep the exhaust pipe's ventilation clear.
IMPORTAN NOTICE: the length of the exhaust hose shall be 280 ~ 1500 mm, and this length is
based on the specifications of the local air conditioner . Do not use extension tubes or replace it
with other different hoses, or this may cause a malfunction. Exhaust host must not be blocked;
otherwise it may cause overheating.
05244_FORCECLIMA 7000_Manual_LI_MV.indd 23
Fig. 4
ENGLISH
Fig. 5
FORCECLIMA 7050
Fig. 6
23
19/12/18 12:51