Accessories - Bosch GOP12V-28 Consignes D'utilisation/De Sécurité

2610042946 04-17 GOP12V-28.qxp_GOP18V-28 4/4/17 7:11 AM Page 11
OPERATING SPEEDS
The Bosch oscillating tools have a high
oscillating motion of 5,000 - 20,000 /min
(OPM). The high speed motion allows the
Bosch tools to achieve with excellent results.
The oscillating motion allows the dust to fall
to the surface rather than slinging particles
into the air.
To achieve the best results when working
with different materials, set the variable
speed control to suit the job (see Speed
Range chart at right for guidance). To select
the right speed for the accessory in use,
practice with scrap material first.
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
The three green LEDs of the battery charge
condition indicator show the charging status of
the battery. The battery charge condition
indicator only illuminates for 5 seconds after
start-up.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Flashing light 3 x green
When no LED lights up after switching on, then the battery is
INSERTING AND RELEASING
defective and must be replaced.
BATTERY PACK
listed in the charger manual included with
The GOP12V-28 is compatible with StarLock family of accessories as indicated in the
following chart
Accessory
injury and property damage.
Capacity
≥2/3
≥1/3
<1/3
Reserve
Empty
Use only Bosch
recommended batteries

Accessories

Accessory Model Number Range
Only use Bosch accessories rated 21000 OPM or greater. Using
accessories not designed for this power tool may result in serious personal
The variable speed control settings are
marked on the speed control dial. The
settings for approximate /min (OPM) are:
Speed Dial
Setting
1
2
3
4
5
6
your tool. Using other types of batteries may
result in personal injury or property damage.
Release battery pack from tool by pressing
on both sides of the battery release tabs and
pull outward (Fig. 1).
Ensure the switch is in
the off position before
inserting battery pack. Inserting the battery
pack into power tools that have the switch on
invites accidents.
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
If battery release tabs are
cracked or otherwise
damaged, do not insert into tool. Battery
can fall out during operation.
OSL
OSP
OSM
-11-
Speed Range
/min (OPM)
5,000
8,000
11,000
14,000
17,000
20,000
GOP12V-28
YES
NO
NO