General information
IMPORTANT SAFETY INSTRUCTIONS
This product requires a three-prong grounded outlet. The installer must perform a
ground continuity check on the power outlet box before beginning the installation
to ensure that the outlet box is properly grounded. If not properly grounded, or
if the outlet box does not meet electrical requirements noted (under ELECTRICAL
REQUIREMENTS), a qualified electrician should be employed to correct any
deficiencies.
CAUTION
For personal safety, remove the house fuse or open the
circuit breaker before beginning the installation to avoid
severe or fatal shock injury.
CAUTION
•
For personal safety, the mounting surface must be capable of supporting the
cabinet load in addition to the added weight of this 69 pound product, plus
additional oven loads of up to 50 pounds or a total weight of 119 pounds.
•
For personal safety, do not install this product in cabinetry configured as an
island or a peninsula. The microwave oven must be mounted to BOTH a top
cabinet AND a wall.
NOTE
For easier installation and personal safety, we recommend that two people install
this product.
IMPORTANT – PLEASE READ CAREFULLY. FOR PERSONAL SAFETY,
THIS APPLIANCE MUST BE PROPERLY GROUNDED TO AVOID SEVERE
OR FATAL SHOCK.
Install_ME11A7510DG_AC_DE68-04709B-00_EN+CFR.indb 3
Install_ME11A7510DG_AC_DE68-04709B-00_EN+CFR.indb 3
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with a
standard three-prong (grounding) wall receptacle to
minimize the possibility of electric shock hazard from
this appliance.
Insure proper
ground exists
before use.
You should have the wall receptacle and circuit checked by a qualified electrician
to make sure the receptacle is properly grounded.
If you have a standard two-prong wall receptacle, it is very important to have
it replaced with a properly grounded three-prong wall receptacle, installed by a
qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM OR REMOVE ANY OF THE
PRONGS FROM THE POWER CORD. DO NOT USE WITH AN EXTENSION CORD.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 14.5 amps and 1.7 kilowatts. This product
must be connected to a supply circuit of the proper voltage and frequency. Wire
size must conform to the requirements of the National Electrical Code or the
prevailing local code for this kilowatt rating. The power supply cord and plug
should be brought to a separate branch circuit single grounded outlet of at least
15 A and max of 20 A. The outlet box should be located in the cabinet above
the microwave oven. The outlet box and supply circuit should be installed by a
qualified electrician and conform to the National Electrical Code or the prevailing
local code.
English 3
2021-06-16
2021-06-16
11:00:48
11:00:48