Husqvarna K 770 Dry Cut Manuel D'utilisation page 62

To adjust the tension of the recoil
spring
1. Put the rope through the cut-out in the starter pulley.
Wind the rope 3 turns clockwise around the center of
the starter pulley.
2. Pull the starter knob to adjust the tension of the
recoil spring.
3. Put the rope through the cut-out in the starter pulley.
Wind the rope 4 turns clockwise around the center of
the starter pulley.
4. Pull the starter knob to adjust the tension of the
recoil spring.
Note:
The starter knob moves into position after
the tension is adjusted.
5. Pull out the starter rope fully and make sure that
the recoil spring is not at its end position. Make the
starter pulley turn slow with your thumb.
6. Make sure that the starter pulley can be turned half
a turn or more before the recoil spring stops the
movements.
To remove the spring assembly
WARNING:
when you remove the spring assembly.
There is a risk for eye injury, especially if a
spring is broken.
62
Always use eye protection
1. Remove the 2 screws on the spring assembly.
2. Push the 2 brackets on the snap locks with a
screwdriver.
To clean the spring assembly
CAUTION:
from the assembly.
1. Blow the spring with compressed air until it is clean.
2. Apply a light oil to the spring.
To attach the spring assembly
• Assemble in the opposite sequence of
the spring assembly on page 62 .
To install the starter housing
CAUTION:
come into the correct position against the
starter pulley sleeve.
1. Pull out the starter rope approximately 0.5 m.
2. Keep the position of the starter rope and put the
starter against the product.
3. Slowly release the starter rope until the starter pawls
are in the correct position.
4. Tighten the 4 screws on the starter.
Do not remove the spring
To remove
The starter pawls must
861 - 005 - 22.04.2022