Lnstall Battery And Charge Pump; Pump Diagram; Set Up Mode - first years Breastflow Memory Pump Manuel D'instructions

Memory Pump
Install battery and charge pump
1. • Turn Memory Pump unit 2. • Turn coin counterclockwise
over to back side • Slide the battery door to
the left.
• Insert coin into lock.
4. Snap rechargeable 5. Secure battery pack into
battery pack compartment first and
connector together. then lay wire down.
7. Insert coin into lock
and turn clockwise .
10 get ready for thefirstyears.com TM
3. Lift battery door off
to expose rechargeable
battery.
6. Align battery door with
4 slots and slide door
into place.
8. Plug adapter into
pump unit to
charge.
Charging the pump for 2.5 hours provides four 15 minute pump sessions.
9. When pump is charged press
the "Power" button.

Pump Diagram

1
2 3 1 Power on button
3 Air tubing plug in
4

SET UP Mode

NOTED: You can begin pumping WITHOUT performing the SET UP MODE.
(Remove plastic cover prior to use.)
Set up: Using a paper clip insert end into reset area
located below Memory Pump screen and press.
2 AC adapter input
4 Reset button
get ready for thefirstyears.com 11
TM