Identification Of Symbols - Poulan PD4016 Manuel D'instructions

IDENTIFICATION OF SYMBOLS

WARNING! Chainsaws
can be dangerous!
Careless or improper
use can result in
serious or fatal injury
to the operator or
others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
Approved protective helmet
·
Approved hearing protection
·
Protective goggles or a visor
·
Both of the operator's hands must
be used to operate the chainsaw.
Never operate a chainsaw holding it
with one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Tip contact
may cause the guide
XX
bar to move suddenly
upward and backward
(so-called kickback),
which may cause
serious injury.
Primer (air purge) bulb.
The engine is stopped by switching
the ignition off using the stop
switch.
Fuel fill.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of operating
hours for which the engine has been shown to meet Federal
emissions requirements.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.
WARNING! The engine exhaust from this
product contains chemicals known to the State
of California to cause cancer, birth defects or
other reproductive harm.
2
50:1 gasoline to oil ratio.
Do not use E15 or E85 blended
fuels.
Bar and chain oil fill.
Lock chain brake.
Unlock chain brake.
Chain brake unlocked/locked.