How To Control Your Model - Hobbytech BX8SL RUNNER Mode D'emploi

BIND
A
Pairing your receiver to your KT2S+
Place model on a block to prevent wheels from touching the
ground.
A
Connect battery to ESC. Fix the wire correctly with the
provided connectors.
You must check the signal of transmitter and receiver before
you operating it at first.
Make sure TH Trim is on neutral
- TURN OFF THE TRANSMITTER AND RECEIVER -
B
Press and Hold the BIND button on the receiver while
turning on the receiver
Release the BIND button when the LED flashes red.
While the red LED flashes, press the BIND button to select the
frame rate.
- Faster flashes= high frame rate (7ms), for digital servo
- Slower flashes= low frame rate (15ms), for analog servo
D
Press and Hold the BIND/EPA key of the Transmitter (1),
and then turn on the transmitter (2), LED flahes green and the
Transmitter will communicate with the receiver. Release the
BIND/EPA button when the receiver LED is solid red, and the
transmitter is solid green, then your receiver is paired with your
transmitter.

HOW TO CONTROL YOUR MODEL

1. Pull up the trigger in order to brake or speed down
2. Pull the trigger in order to go forward or speed up
6
C
.
FORWARD / SPEED
UP POSITION
LEFT
If the wheels operate in the opposite direction,
operate the servo reverse switch (ST in position NOR).
B
C
(2)
D
NEUTRAL
RIGHT
(1)
BRAKE / SPEED
DOWN POSITION
NEUTRAL POSITION