2. Align the Paper Template's Centre Line with the
centre of your TV (if you are mounting the
Soundbar below your TV), and then fix the Wall
Mount Guide to the wall using tape.
c If you are not mounting below a TV, place the
Centre Line in the centre of the installation area.
A
B
CENTER LINE
Centre Line
3. Push a pen tip or sharpened pencil tip through the
centre of the A-TYPE images on each end of the
Guide to mark the holes for the supporting
screws, and then remove the Wall Mount Guide.
4. Using an appropriately sized drill bit, drill a hole in
the wall at each marking.
c If the markings do not correspond to the
positions of studs, make sure you insert
appropriate anchors or mollies into the holes
before you insert the support screws. If you use
anchors or mollies, make sure the holes you drill
are large enough for the anchors or mollies you
use.
A
A
B
B
CENTER LINE
CENTER LINE
A
B
A
A-TYPE : 616mm
B-TYPE : 360mm
A-TYPE : 616mm
A-TYPE : 616mm
B
B
A
B-TYPE : 360mm
B-TYPE : 360mm
· 15 · English
5. Push a screw (not supplied) through each
Holder-Screw, and then screw each screw
firmly into a support screw hole.
6. Use the two Screws (M4 x L12) to attach both
Bracket-Wall Mount L and R to the Soundbar's
bottom. For a proper fit, make sure to align the
bumps on the Soundbar to the holes on the
brackets.
When assembling, make sure the hanger part
●
of Bracket-Wall Mounts faces backwards.
Rear side of Soundbar
Right end of Soundbar
The left and right mounts are different shapes.
●
Make sure to position them correctly.
Wall Mount R
Wall Mount L