Selecting The Abs Function - MV Agusta F4 RR Manuel De L'utilisateur

4.4.7. Selecting the ABS function *

Press "SET" in order to access to "ABS" mode;
"SETTING ABS" appears on the display.
WARNING
The display modes may be changed or set
when the engine is off, the gear in neutral, the
motorbike stationary with your feet on the
ground. Do not change the display while dri-
4
ving.
Press "OK" for less than three seconds: the display
shows the last memorized selection. Under standard
conditions, "ABS NORMAL" (ABS function for use on
road) will start blinking on the display.
If you do not press any button, after three seconds
the "ABS NORMAL" selection is confirmed; under this
condition, the ABS function for use on road is activated.
Press "SET" to exit the "ABS" mode.
(*): This function is present only on certain models
OPERATION
- 58 -
4