Filter Cleaning - Hoover WM AXI Mode D'emploi

Filter cleaning

l
The washing machine comes with a
special filter able to trap large residue,
such as buttons or coins, which could
clog the drain (according to the model,
consider version A or B).
l
ONLY AVAILABLE ON CERTAIN MODELS:
pull out the corrugated hose, remove the
stopper and drain the water into a container.
l
Ensure all the water has been emptied
from the drum.
l
Before unscrewing
recommend you place an absorbent cloth
under it to keep the floor dry. A small
amount of water will come out of the filter
as you remove it - this is normal.
l
Turn the filter counter-clockwise to the
limit stop.
l
Remove and clean the filter; when
finished, replace it turning it clockwise.
The filter handle will be locked when it is
not possible to turn any further and the
handle is horizontal. Smearing a small
amount of liquid soap on the filter seal will
help refitting.
l
Repeat the previous steps in reverse
order to reassemble all parts.
A
B
the filter, we
68
S u g g e s tio n s fo r m o v e s o r
prolonged disuse
l
Should the washing machine be stored in
an unheated room for a long period of
time, drain all water from tubes.
l
Unplug the washing machine.
l
Detach the tube from the drainage system
and clip on the rear of the machine and
lower it, fully draining water into a bowl.
l
Secure the drain tube with the drainage
system and clip on the rear of the
machine when finished.
l
Keep the door glass and gasket clean.
FOR MODELS
LIQUID DETERGENT AND SOFTENER
DOSING SYSTEM:
should you need to tilt or move the
machine, remove the detergent drawer
before proceeding,
horizontal so as to avoid any leakage.
WITH AUTOMATIC
keeping it