Cleaning The Pump Filter - Hoover H-WASH 700 Mode D'emploi

Cleaning the pump filter

l
The appliance has a special filter that
traps larger residues that could block the
draining system, such as buttons or coins
(depending on
version A or B).
We recommend checking and cleaning
the filter 5 or 6 times a year.
l
Disconnect the machine from the power
supply.
l
Ensure all the water has been emptied
from the drum.
l
Before unscrewing
recommend you place an absorbent cloth
under it to keep the floor dry. A small
amount of water will come out of the filter
as you remove it - this is normal.
l
Turn the filter counter-clockwise to the
limit stop.
l
Remove and clean the filter; when
finished, replace it turning it clockwise.
The filter handle will be locked when it is
not possible to turn any further and the
handle is horizontal. Smearing a small
amount of liquid soap on the filter seal will
help refitting.
l
Repeat the previous steps in reverse
order to reassemble all parts.
A
B
the model, consider
the filter,
S u g g e s tio n s fo r m o v e s o r
prolonged disuse
l
If the appliance is kept in a non-heated
room for long periods of time, all water
residues must be completely removed
from the pipes.
l
Disconnect the machine from the power
supply socket.
l
Detach the tube from the drainage system
and clip on the rear of the machine and
we lower it, fully draining water into a bowl.
l
Secure the drain tube with the drainage
system and clip on the rear of the
machine when finished.
l
Keep the door glass and gasket clean.
FOR MODELS
LIQUID DETERGENT AND SOFTENER
DOSING SYSTEM:
should you need to tilt or move the
machine, remove the detergent drawer
before proceeding,
horizontal so as to avoid any leakage.
72
WITH AUTOMATIC
keeping it