Black & Decker DVJ215B Manuel D'utilisation page 6

ENGLISH
To retract the crevice tool (4) press the crevice tool release
u
button (4a) allowing it to return to its normal position
(Fig. B).
Note: The flip down brush (8) can only be utilised when the
crevice tool is in the retracted position.
Charging (Fig. D)
Place the appliance onto the charging base (7) and plug
u
into the electrical outlet.
Switch the electrical outlet on. The LED charging indicator
u
(B) will illuminate.
Dual LED Display
B
C
B. LED Charging display
Battery icon is illuminated when appliance is switched on
and will flash when the battery is almost depleted
charging. It will also flash during charging (See LED
pattern chart in this manual).
C. BOOST mode
Illuminates when the appliance is in BOOST mode.
6
(Original instructions)
LED Patterns
Cleaning the filters (Fig. E, F, G, H, I, J)
Press the dust bowl release button (12) (Fig. E).
u
Eject the dust bowl (6) (Fig.F).
u
Lift the filter assembly (10) using the metal handle provid-
u
ed from the dust bowl (6).
Empty the dust bowl (6) by lightly shaking over a dustbin
u
(Fig. H).
The filter (11) can now be removed from the filter assem-
u
bly (10) (Fig. I).
Empty any remaining dust from the dust bowl.
u
Rinse out the dust-bowl with warm soapy water.
u
Wash the filters with warm soapy water (Fig. J).
u
Make sure the filters are dry.
u
Refit the filters into the appliance.
u
Close the dust-bowl. Make sure the release latch (8) clicks
u
into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water.
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
Run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Charging
Battery Fault
Charger Fault
Battery Hot