Bosch GDA 280 E Professional Notice Originale page 18

OBJ_BUCH-428-002.book Page 18 Wednesday, November 12, 2008 3:21 PM
18 | English
To remove the sanding sheet 4, grasp it at one
of the tips and pull it off from the sanding plate
5.
Sanding accessories, such as fleece pads/pol-
ishing cloth pads, are attached to the sanding
plate in the same manner.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For the working of all
wooden materials
For coarse-sanding, e. g.
of rough, unplaned
beams and boards
For face sanding and
planing small irregulari-
ties
For finish and fine sand-
ing of hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of prim-
ers before coating
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
1 609 929 N92 | (12.11.08)
Replacing the Sanding Plate
(see figure C)
If, e. g., the front tip of the sanding sheet is
Grain size
worn, you can also remove the complete sand-
40—240
ing plate and reattach it turned by 120°.
Specialty Sanding Plates
You can replace the supplied sanding plate 5
coarse 40, 60
with a specialty sanding plate, which is available
as an accessory.
The specialty sanding plate is attached in the
medium 80, 100,
same manner as the one supplied.
120
Attach and remove the respective sanding
sheets in the same manner as when changing
fine 180, 240
original sanding sheets.
Pad Extender (see figure D)
40—320
With the pad extender 8 you can sand surfaces
that are difficult to access, such as sills on win-
dows, cabinets or doors.
Pad Extender, Narrow (see figure E)
coarse 40, 60
With the narrow pad extender 10 you can sand
medium 80, 100,
narrow openings, slots and passages.
120
Pad Extender, Narrow Rounded (see figure F)
fine 180,
The narrow rounded pad extender 11 allows you
240, 320
to sand curved and hollow areas or surfaces that
are curved inward, such as on furniture, rails or
heating radiators.
Slide the SDS button for release of the sand-
ing plate 6 all the way to the right.
Remove the sanding plate 5.
Guide the sanding plate 5 from below
against the sanding plate holder and firmly
press them together.
Slide the SDS button for release of the sand-
ing plate 6 all the way to the left.
Bosch Power Tools