Mittelmann KB1-12KM Mode D'emploi page 11

Labeling flexible anchor line:
Anchor line for fall arrester
KB1-12KM, AH3-12KM, AH4(F)-12KM
KM-rope Ø 12 mm
length: xxx m
Labeling fall arrester and flexible anchor line:
Mittelmann Sicherheitstechnik
Bessemerstr. 25, 42551 Velbert Address of the manufacturer
www.mittelmann.com
year of manufacture: XX/XXXX
EN 353-2:2002
serial number: xxxxxxxx
0158
4. Servicing and Storage
On finishing work clean, dry and store the guided type fall arrester including a flexible anchor line

in well aired and shady rooms.
During transportation of the guided type fall arrester including a flexible anchor line it must be

stored in a suitable transport container (for example equipment bag or equipment case).
Avoid contact with acids, corrosive fluids and oils. If unavoidable, clean with a mild detergent and

plenty of water (40°C) as soon as possible. Always allow to dry naturally, never close to fire or
other sources of heat.
Please contact the manufacturer of the guided type fall arrester including a flexible anchor line in

the event of questions concerning disinfection.
Attention: Adhere strictly to the cleaning instructions!!
5. Material Specifications
Guided type fall arrester:
Ropes, harness straps and plastic parts:
Karabiner hook:
6. Length of Use
The operating depends on the respective conditions of use. Based on previous experience, under
normal conditions of use, the textile components of the guided type fall arresters including a flexible
anchor line can be assumed to be used for 8 years. The year of manufacture is entered on the label.
7. Inspection
Before starting work inspect the guided type fall arrester including a flexible anchor line, lanyards,

karabiner hooks and energy absorber for wear of damage. Check the function of the guided type
fall arrester and the karabiner hooks. Check the legibility of the marking.
Should there be any doubts about the safe condition of the system or its components, then they

are to be replaced immediately. This must be carried out by the manufacturer or another
competent person. The checking before use of certain equipment components intended for use
in an emergency can be dispensed with if these have been packed or sealed by a competent
person.
As required, but at least once a year, have an inspection carried out by the manufacturer or a

competent person. The yearly check by the manufacturer or a competent person is absolutely
necessary as the safety of the user is dependant upon the effectiveness and the stability of the
Information about fall arrester that may be used
on this flexible anchor line
flexible anchor line sheathed core rope Ø12 mm
Length of the flexible anchor line
Manufacturer Mittelmann Sicherheitstechnik GmbH & Co. KG
Internet address of the manufacturer
Month/Year of Manufacture
Number and year of the document to which the equipment
complies
Serial number fall arrester / flexible anchor line
Identification number of the notified inspection body
The user must read and observe the Instructions for Use!
Stainless steel
Polyamide
Aluminium or steel