Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Symptom
Possible Cause(s)
Tool runs slowly
1. Grit or gum in tool.
or will not operate.
2. No oil in tool.
3. Low air pressure.
4. Air hose leaks.
5. Pressure drops.
Moisture blowing
1. Water in tank.
out of tool.
2. Water in the air lines/hoses.
General Troubleshooting Guide
1. Flush the tool with air tool oil, gum solvent, or an
equal mixture of SAE # 10 motor oil and kerosene.
Lubricate the tool after cleaning.
2. Lubricate the tool according to the lubrication
instructions in this manual.
3. Adjust the compressor regulator to tool maximum
while the tool is running free.
4. Tighten and seal hose fittings if leaks are found.
5-1. Be sure the hose is the proper size. Long hoses
or tools using large volumes of air may require a
hose with an I.D. of 12.7 mm (1/2") or larger depen-
ding on the total length of the hose.
5-2. Do not use a multiple number of hoses connec-
ted together with quick connect fittings. This causes
additional pressure drops and reduces the tool power
Directly connect the hoses together.
1. Drain tank. (See air compressor manual).
Oil tool and run until no water is evident.
Oil tool again and run 1-2 seconds.
2-1. Install a water separator/filter.
Note: Separators only work properly when
the air passing through the separator is cool
Locate the separator/filter as far as possible
from the compressor.
2-2. Install an air dryer.
ENGLISH
Corrective Action
18
Publicité
Table des Matières
