HoMedics SDN-4000ATNDY Manuel D'instructions page 4

PRODUCT FEATURES Unique Gel nodes provide a smooth, natural touch massage
INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with a screw located on the back of the unit to
protect the massage mechanism during shipment, which must be removed
before the first use to allow the shiatsu feature to function. Use the
provided Allen key. Then, properly dispose of the screw.
WARNING – Failure to remove screw may cause permanent
damage to the appliance.
Error: all remote control LEDS flash for a few seconds.
Cause: massager overloaded.
Solution: ensure the allen key bolt/screw has been removed from back of
the massage cushion (using the allen key included). Should the condition
continue after this please contact your HoMedics service centre.
Strapping System
The Gel Shiatsu Massager incorporates a unique strapping system which
allows you to fasten it to almost any chair. Just slip the straps over the seat
or chair and adjust fastening straps to secure. Your massager won't slip or
slide away.
Note: Do not use this product for more than 15 mins at a time.
The moving dual massage mechanism on the back always "parks" or
finishes in its lowest position. It will continue to this position after the
power has been turned off. If the electrical supply is interrupted, when
power is restored, the mechanism will "park" or move to its lowest position.
FKA Brands Ltd
Somerhill Business Park, Tonbridge, Kent TN11 0GP, UK
Customer Support: +44(0) 1732 378557 | support@homedics.co.uk
DEMO BUTTON - For a brief demonstration of the features
of the Shiatsu Massaging Cushion, press the Demo button.
The unit will briefly go through each function. Once complete,
the unit automatically turns off. The L.E.D. light will blink to
indicate the active functions.
SHIATSU GEL MASSAGE - A deeply relaxing and rejuvenating
experience invented in Japan using rhythmic finger pressure to
stimulate 'chi' (vital energy), relieving stress and tension.
SHIATSU PROGRAMS - Choose from 3 preset
programs where the Shiatsu massage travels up and down in
a specific area of the back. To select a program, simply press
the button and the LED will illuminate. To deselect, press the
button again or press another button.
Full back Upper back
SPOT SHIATSU - While the unit is in Shiatsu massage,
press either button to stop and focus the Shiatsu action in one
place. Once the unit is operating in Spot Shiatsu, you may
adjust the mechanism position by holding
down either button until the desired position
is reached. The Up Arrow will move the
mechanism upwards and the Down Arrow will
move it down. Once you release the button, the
mechanism will stop in that place.
3-SPEED SETTING - To change the speed
of the massage mechansim press '3 Speed'
button to change between low, medium and
high. The speed setting selected is shown by
the lights below.
POWER BUTTON - To turn on the unit,
q
first press the POWER button. The LED indicator
will illuminate and confirm your selection.
To turn off the unit, simply press the button again. The LED
indicator will blink while the back massage mechanism returns
to its lowest point and then it will turn off.
VIBRATION MASSAGE
massage to any shiatsu or rolling massage program.
PERFECT FIT - To customize the massage to your height,
press the "Perfect Fit" button at the highest desired position.
The massage heads will not travel higher than that position for
the duration of the massage. To deselect the Perfect Fit feature,
press the "Perfect Fit" button a second time. The massage will
return to its full travel.
ROLLING MASSAGE - Rolling is like two hands or thumbs
working up and down your back.
ROLLING PROGRAMS - Choose from 3 preset programs
Lower back
where the Rolling massage travels up and down in a specific
area of the back. To select a program, simply press the button
and the LED will illuminate. To deselect, press
the button again or press another button.
Aroma tab
Moving Gel Shiatsu
massage mechanism
Using essential oils
with the aroma tab
Gently pour a few
drops of oil onto the aroma
tab, releasing the scent in
the air. The more drops,
the stronger the scent.
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a
soft, slightly damp sponge.
• Never allow water or any other liquids to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint
thinner etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact
with sharp edges or pointed objects which might cut or puncture the
fabric surface. To avoid breakage, DO NOT wrap the power cord around the
appliance. DO NOT hang the unit by the cord.
GB
- Add invigorating vibration
WIDTH ADJUSTMENT - While the
unit is in Rolling massage for the back, press
this button to adjust the distance or width
between the massage heads. With each press,
the massage heads will move to the next
available position.
GENTLE HEAT - For gentle soothing heat
when massage is on, simply press the gentle
heat button and the corresponding red L.E.D.
light will illuminate. To deselect, press the
button again and the corresponding L.E.D.
light will turn off.
For your safety, gentle heat cannot be
turned on if massage is not selected.
IB-SDN4000ATNDY-0320-01