Belt Adjustment - BLUEFIN Fitness KICK 2.5 Mode D'emploi

BELT ADJUSTMENT

The running belt is pre-adjusted to the running deck at the factory, but after prolonged
use it can stretch and require readjustment. To adjust the belt, turn on the main power
switch of the treadmill and let the belt run at a speed of 8-10 KPH. Use the 6 mm Allen
Wrench provided to turn the rear roller adjustment bolts in order to centre the belt. If the
running belt is shifting to the left, turn the left adjustment bolt 1/4 turn clockwise, and
the running belt should start to correct itself.
If the running belt is shifting to the right, then turn the right adjustment bolt 1/4 turn
clockwise, and the belt should start to correct itself. Keep turning the adjustment bolts
until the running belt is properly centered.
6mm Allen Wrench
BELT ADJUSTMENT
If the running belt is slipping during use, turn off and unplug the treadmill. Using the 6
mm Allen Wrench provided, turn both left and right rear roller adjustment bolts 1/4 turn
clockwise, then turn the main power switch back on and run the treadmill at a speed of
8-10 KPH. Run on to the running belt to determine if the belt is still slipping. Repeat this
procedure until the belt no longer slips.
(cont.)