Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Do not depress trigger when connecting the air supply hose.
8.
Always use attachments designed for use with air powered tools. Do not
use damaged or worn attachments.
9.
Never trigger the tool when not applied to a work object. Attachments
must be securely attached. Loose attachments can cause serious injury.
oil and sharp edges. Replace any hose that is damaged, weak or worn.
10. Protect air lines from damage or puncture.
11. Never point an air tool at oneself or any other person. Serious injury
could occur.
12. Check air hoses for weak or worn condition before each use. Make sure
all connections are secure.
any maintenance.
Loose attachments could fly off during operation and cause serious injury.
Only use attachments rated at or above tool rated 20,000 RPM.
during first few seconds of operation after an airtool has been lubricated.
Failure to cover exhaust port can result in serious injury.
13. Keep all nuts, bolts and screws tight and ensure equipment is in safe
working condition.
14. Do not put hands near or under moving parts.
15. Always secure workpiece in a vise or clamp. Do not place hands on the
back cylinder when operating the tool.
16. Do not use a cut-off disc mandrel on this tool unless a safety guard is in
place.
work motions can cause injury to hands and arms. Stop using any tool if
discomfort, numbness, tingling, or pain occur, and consult a physician.
Use of a whip hose prevents accidental triggering of
tool when pressurized air is connected to system.
Never carry a tool by the hose or pull hose to move
tool or a compressor. Keep hoses away from heat,
Release all pressure from the system before
attempting to install, service, relocate or perform
Disconnect air tool from air supply before changing
attachments or serious injury could occur.
Make sure attachment shank is fully inserted into
collet opening and collet is securely tightened.
This air tool requires lubrication before initial use
and before and after each additional use.
Disconnect air tool from air supply before
lubricating.
Cover exhaust port with a towel before applying air
pressure. Oil will discharge through exhaust port
Do not misuse this product. Excessive exposure to
vibration, work in awkward positions, and repetitive
7
Publicité
Table des Matières
