Important Note To Installer; Selecting A Location - Samsung WF328AA Mode D'emploi

IMPORTANT NOTE TO INSTALLER

Please read the following instructions carefully before installing your Washer.
These instructions should be retained for future reference.
We recommend you hire a professional for installation of this washer.
STEP 1
Removing the Shipping Bolts
Before using your Washer, you must remove the four
shipping bolts from the back of the unit.
1. Loosen all bolts with the supplied spanner.
2. Slide the bolt and spacer up and remove the bolt with
the spacer through the hole in the rear wall of your
washer. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
STEP 2

Selecting a Location

Before you install your washer, make sure the location:
•
•
•
•
•
•
•
STEP 3
Installing your Washer
1. Place the drain hose in the drain facility. Be
sure an airtight connection is NOT made
between the drain hose and the standpipe.
The standpipe must be at least 18 in or 46
cm high.
Caution must always be exercised to
avoid collapsing or damaging the drain
hose. For best results, the drain hose
should not be restricted in any way – by
elbows, couplings, or excessive lengths.
For situations where the drain hose
cannot be conveniently elevated to at
least 18 in or 46 cm, the drain hose must
be supported.
WF337A-02440A-06_EN.indd 9
Has a hard, level surface
Is away from direct sunlight
Has adequate ventilation
Will not be freezing (below 32°F or 0°C)
Is away from heat sources such as oil or gas
Has enough space so that your Washer need not stand on its power cord
Doesn't have any carpeting that will obstruct ventilation openings.
Installing your washer _9
2007-08-10 ¿ÀÈÄ 2:07:37