Important Note To Installer; Installation Flow Chart - Samsung WF42H5200A Serie Mode D'emploi

ImPOrTAnT nOTe TO InSTALLer

Please read the following instructions carefully before installing the washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.

Installation flow chart

Selecting a
Please
check again
before
steps.
Yes
stEp 1
removing the Shipping Bolts
Before using your washer, you must remove all shipping bolts from the
back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with the spacer
through the hole in the rear wall of your washer. Repeat for each
bolt.
3. Cover the holes with the supplied Bolt Hole Covers (See page 11).
4. Keep the shipping bolts and spacers for future use.
stEp 2
Selecting a Location
Before you install your washer, make sure the location:
• Has a hard, level surface.
• Is away from direct sunlight.
• Has adequate ventilation.
• Will not freeze (tempuratures are never below 32 °F or 0 °C).
• Is away from heat sources such as oil or gas.
• Has enough room for the power cord.
• Doesn't have any carpeting that will obstruct ventilation openings.
BETTER_WF42H5200-03397A-12_EN.indd 15
Removing the shipping
location bolts (*Drum only)
Adjusting the
levelling feet
Does
your washer
have excess vibration
or noise?
Connecting the water
and the drain
Powering your washing
machine
Running a Calibration mode
(Refer to the following
description)
No
English _15
[running a test cycle]
Run a test cycle (Rinse+Spin) with
small amount of laundary
(about 4~5 Towels)
Finish the
installation
2017/6/1 11:30:05