Publicité
5037
ART.
THERMOSTATIC
SHOWER WITH
UPPER AND LOWER EXIT
Fig.1: INSTALLATION
HOT
COLD
WATER
WATER
Wind the Teflon tape around the thread G.1 / 2 " of the eccen-
tric connectors (1) to ensure the hydraulic seal and screw
them to the hot and cold supply pipes making sure that all
pipes are free of limescale and dirt.
Insert the washer (2) inside the nut (4). Fit the rose covers (3)
and tighten the nuts (4) on the eccentric connectors (1) with
the spanner.
FIG.3: USE
DIVERTER
SHOWER HEAD
STOP POSITION
POSITION
TEMPERATURE
COLD
SAFETY CATCH
HOT
Push the button and rotate the
TEMPERATURE
handle in order to obtain tempe-
SETTING
ratures above 38°C.
Fig.2: MAINTENANCE
Using a screwdriver, remove the covers (7), unscrew the screws (8) and (13)
and extract the handles (9) and (12).
To remove the thermostatic cartridge (10), unscrew the screw (6) with a screw-
driver; and using a pincer remove the cartridge (10) from the body (15).
To remove the diverter cartridge (16), with a spanner CH.24 unscrew the hol-
ding-bush (17); then remove the diverter cartridge (16) from the body (15) with
a pincer.
To re-assemble, follow the above procedure in reverse order
HAND SHOWER
POSITION
This product has been tested
up to 10 bar water pressure.
Ce produit a été testé fin à une
pression de 10 bars.
Publicité
