Available Options - DeFelsko PosiTest AT-M Mode D'emploi

Masquer les pouces Voir aussi pour PosiTest AT-M:

Mode d'emploi (44 pages)

Table des Matières

Les langues disponibles

Step 5: Analysis of Test Results

Test results can be considered 100% valid when the coating is completely

removed from the substrate. When only a portion of the coating is removed, spe-

cific results should be noted including the fracture pattern to determine the cohe-

sive properties of the coating and adhesion properties between the dolly and

adhesive, adhesive and coating, distinct coating layers, and coating and sub-

strate.

Step 6: Storing Pull-Off values into Memory

The PosiTest's internal memory stores maximum pull pressure, pull rate,

test duration and dolly size for up to 200 pulls.

Press the

results. The display will show the pull rate and alternate between the test

number and the maximum pull pressure for that test. The

appear to indicate that there are test results in memory.

Press the

The PosiTest AT-A also displays dolly size

pressing their respective buttons.

Complete information on all test results can be downloaded to a PC and

viewed using the optional PosiSoft software. Test results are not erased

from memory after downloading. Press

(AT-A automatic) to exit viewing mode.

To remove all stored test results from memory, press and hold the

button, then press the

disappear from the display.

All settings and test results in memory are retained during power-down.

A variety of accessories are available to help you get the most out of your

PosiTest Pull-Off Adhesion Tester.

button upon completion of a test to store pull-off test

button repeatedly to view previously stored test results.