Adjust Machine Height; Preventive Maintenance; Preventive Maintenance Schedule - strapex SMA 20 Mode D'emploi

Strapex SMA 20

6.8 ADJUST MACHINE HEIGHT

The table height is adjustable from 700 to
830 mm.
– Hold machine and loosen two cylinder screws
(10/1) on one of the legs (10/2).
– Adjust leg to required height and tighten up cylinder
screws again.
Never loosen two legs at the same time (risk
of tipping over)!
– Adjust the other legs to the same height.
– Lock both locking wheels before strapping.
7
For preventive maintenance, disconnect the
power plug!
The machine requires little maintenance. All bearings
are permanently lubricated.

7.1 PREVENTIVE MAINTENANCE SCHEDULE

Task
1. Blow out sealing head, strap guides and fan with
compressed air.
2. Clean heating element with fi ne emergy cloth (do
not bend heating element).
First allow heating element to cool down.
3. Clean clamp, strap separator and slide plate (see
Chapter 7.2).
4. Replace tension belt (see Chapter 7.5).
28
Fig. 10
1 Cylinder screw
2 Leg

PREVENTIVE MAINTENANCE

„mushy" contamination in the presence of fi ne strap
dust particles, which cause blockage of moving parts.
Interval
Weekly
•
Protect tensioning belt from lubricants! Do
not use any oil! The use of oil can lead to
Monthly
•
•
1
2
after approx.
100000 strappings
•
02.11