Declaration Of Conformity; General Information; Modes Of Operation - strapex SMA 20 Mode D'emploi

Strapex SMA 20
We take sole responsibility for declaring that the
machine SMA 20, to which this declaration refers,
is in full compliance with the current requirements
of the guidelines laid down by the council on 17th
May 2006 (2006/42/EEC) "Machine Guidelines".
Furthermore, electrical installations are in compli-
ance with the guideline laid down by the council on
12. December 2006 (2006/95/EEC) "Low Voltage
Guidelines" and from 15. December 2004
(2004/108/EEC) "EMV Guidelines".
According to norm:
EN ISO 12100-1, EN ISO 12100-2, EN 349,
2
These operating instructions are intended to simplify
familiarisation with the machine and the ways in which
it may be used for the intended purpose. The operat-
ing instructions contain important information concern-
ing the safe, proper and effi cient use of the machine.
Compliance with the instructions will help to avoid
danger, reduce repairs and stoppages and increase
the reliability and service life of the machine.
The operating instructions must always be available
at the place of operation of the machine. They must
be read and observed by all persons concerned with
work on the machine. This work specifi cally includes
oper-ation, refi lling of operating material, fault elimina-
tion and maintenance.
In addition to the operating instructions and the regu-
lations for accident prevention effective in the country
of use and place of application, the recognised tech-
nical regulations for safety and proper working must
also be observed.
3
A difference is drawn between normal and special
operation:
– Normal operation
The machine is in normal operation when the
package is strapped without fault. These tasks are
described in chapter 6 (exception: chapter 6.5 and
6.8).
For normal operation it is assumed that the machine is
correctly connected to the mains and switchrd on, the
strap is correctly inserted.
20

DECLARATION OF CONFORMITY

EN ISO 13857, EN ISO 13850, EN 61000-6-2,
EN 61000-6-3, EN 50371, EN 415-8
EEC-Design certifi cation: 1053
Place of certifi cation:
Accreditation:
CH-8953 Dietikon, 18.12.2009
General Manager
Technology:
U. Schweizer
Authorized person for the publication of technical documentation:
M. Stutz, ORGAPACK GmbH, Silbernstr. 14, 8953 Dietikon

GENERAL INFORMATION

MODES OF OPERATION

– Special operation
The machine is in special operation when it cannot
comply with normal operation conditions. This is the
case when changing strap coil, and during fault
elimination, cleaning and maintenance (chapter 7
and 8).
NSBIV AG, SIBE CH,
No. SCES 046
Manager Products
Packaging Technology:
M. Binder
CAUTION!
Used where there is dan-
ger to life and health.
WARNING!
Used for danger which
can cause material
damage.
NOTE!
Used for general infor-
mation and information
which if not followed can
cause faults in the
operating sequence.
02.11