Celestron 44302-A Mode D'emploi page 9

u d M S (dMS)
SIng the IgItal IcroScope uIte
S
oftware
Plug in the USB cable of the Microscope to your computer and then start DMS.
The DMS contains basic image capture and organization for your photos
(snapshots) and videos. Click on the DMS icon to begin.
The software is very intuitive and easy to use. You can change settings
by using File and Settings – the Video Device should have as a default
"Celestron Digital Microscope," if not please change it so the DMS will
function properly.
You can take snapshot images by using the snapshot button on the
microscope (only with Windows OS's) or you can also use the keyboard by
clicking enter on "Capture an Image." For videos you need to start/stop on
the icon shown on the screen. If the image delays or starts/stops, you should
lower the video resolution in the "Settings."
Measuring Function — DMS has a simple measuring function which measures
the distance between two points in millimeters. Click the "Measure" button
on the bottom right of the screen. Start by selecting "Low Power" or "High
Power." Click where you want your starting point and then click again to set
the ending point and it will display the distance between the two points. You
can adjust either point by dragging the pin. You can click "Clear" to start over.
The accuracy is 1/100 of a millimeter.
th
You are now ready to begin your digital adventure!
8