Smartwares CS97DVR Instructions D'installation Et D'utilisation page 111

Receiver can not
record
CS97DVR Can not
remote view
‧Record schedule does not setup properly
→ Set a proper schedule to each camera to enable recording
‧Storage media not ready
→ Use recommended storage media brand/model/spec, check
appendix.
→ Install/uninstall storage media AFTER MONITOR is powered off.
→ Format storage media on the console, then try again.
→ Only install one HDD or Flash disk to monitor.
‧CS97DVR is not connected to internet properly
→ Make sure router DHCP and UPnP is enabled.
→ TCP port #6000 and TCP port #80 should be opened. CS97DVR
may use some numbers of UDP ports assigned by your home
router for network transmission. Please make sure these ports are
opened. Consult your router provider for details if necessary.
→ Make sure the Ethernet cable connection to router is solid.
→ Connect CS97DVR directly after the router, do not connect
CS97DVR to router through a hub or switcher.
→ Exit CS97DVR menu then try again.
→ Make sure the bandwidth is sufficient enough. Each remote
connection requires 1.5Mbps.
→ Make sure Android pad/smart phone is 1.5G/dual core processor;
iPhone4S/New iPad or above
→ General routers require 30 seconds to initiate CS97DVR netwrok
connection.
→ Maximium number of remote viewer is 3, the 4th connection may
be rejected.
53