Preset Time Setting - Gree XK64 Manuel De L'utilisateur

6.5.3 Preset Time Setting

In the PRESET mode, hot water is prepared in advance by the preset time.
In the main interface of the PRESET mode, press the TIMER button to enter the
selection interface. PRESET 1 blinks while PRESET 2 and PRESET 3 are not
displayed. Press ▲ or ▼ and the LCD blinks circularly in the flowing sequence:
PRESET 1 – PRESET 2 – PRESET 3 – PRESET 1.
Preset time setting: Press the TIMER button to select PRESET 1. Then the
PRESET 1 icon is on and the hour value blinks. Press ▲ or ▼ to adjust the hour value
and press the TIMER button to confirm setting. Then the minute value flickers. Press ▲
or ▼ to adjust the minute value and press the TIMER button to confirm setting. After
time setting for PRESET 1 is saved, the main interface is displayed.
PRESET 2 or PRESET 3 setting: Press the TIMER button to select PRESET 2
and then the ON icon blinks. Press ▲ or ▼ to switch the ON and OFF icons. When the
ON icon blinks, press the TIMER button. Then the PRESET 2 icon is on and the ON
icon is off. The hour value blinks. Press ▲ or ▼ to adjust the hour value and press the
TIMER button to confirm setting. Then the minute value flickers. Press ▲ or ▼ to
adjust the minute value and press the TIMER button to confirm setting. After time
setting for PRESET 2 is saved, the main interface is displayed. The method for setting
PRESET 3 is the same as that for PRESET 2. (After setting is saved, the ON and OFF
icons are not displayed in the main interface as these icons are available in the setting
process.)
In the time presetting process, if no button is pressed within 15 seconds the preset
interface will switch to the main interface automatically and setting will not be saved.
If the time preset for PRESET 1, PRESET 2, and PRESET 3 is the same, it is
regarded as one timer.
The preset time can be memorized. If the preset time does not need to be reset,
users only need to select on or off.
Preset time cancelling: After time is preset for PRESET 2 or PRESET 3, users
can press the TIMER button to display the selection interface. The icon of PRESET 2
blinks. Press ▲ or ▼ and the LCD blinks circularly in the flowing sequence: PRESET 2
– PRESET 3 – PRESET 1 – PRESET 2. Select PRESET 2 and press the TIMER button.
Select to cancel PRESET 2. Then the PRESET 2 icon is on and the ON icon blinks.
Press ▲ or ▼ to select OFF. Press the TIMER button to confirm cancelling and return
to the main interface. The method for cancelling preset time for PRESET 3 is the same
Controller For The Air Source Heat Pump Water Heater
9