Table des Matières
Publicité
WHEN NOT IN USE:
Always UNPLUG the Multi-Rotor Hub's LiPo battery when not in use or when Multi-
Rotor Hub is being stored or transported. Store the LiPo battery and Multi-Rotor Hub
in a dry area at room temperature. Avoid temperatures less than 40°F/4°C and greater
than 120°F/49°C. Do not leave the LiPo battery in a car or exposed to direct sunlight. If
exposed to temperatures greater than 120°F/49°C, the LiPo battery can be damaged or
may catch fire.
CAUTION:
NEVER APPROACH MULTI-ROTOR HUB WHILE THE PROPELLER BLADES ARE STILL
SPINNING. THROTTLE DOWN UNTIL THE BLADES STOP THEN TURN OFF REMOTE
BEFORE ATTEMPTING TO HANDLE MULTI-ROTOR HUB.
WARNING:
Do not fly with broken or damaged propeller blades as it may cause damage or lead to
injury.
DO:
Keep your drone in sight at all times.
Check your drone before each flight, plan your flight and learn from others.
Keep away from airports and helipads.
Remember you are responsible for avoiding collisions.
You must have permission to do paid work with your drone.
DO NOT:
DO NOT fly in any way that could endanger anyone.
Choose an unobstructed site and
DO NOT fly overhead people, property or vehicles.
DO NOT fly within 50 meters (164 feet) of people, property or vehicles.
DO NOT fly higher than 150 meters (492 feet) from the ground.
DO NOT fly near airplanes or helicopters.
Recharging the Multi-Rotor Hub Battery
Fully charge the LiPo battery before use.
1
Disconnect the plug from
the Multi-Rotor-Hub.
2
Connect the USB charging cable to
the plug.
Reverse these steps when the battery is fully charged.
3
The USB charging cable can be
connected to any PC or an external
USB wall charger.
4
The light will turn OFF when fully
charged.
(USB wall charger not included.)
Replacing the Prop and Prop Guards
1
2
3
4
TOP VIEW
C
A
B
D
A
B
E
E
C
PROP 1
BATTERY CONNECTION
A
D
B
PROP 2
E
LED LIGHTS
C
PROP GUARD
Use the propeller removal tool
to gently remove a damaged
prop off.
Replace damaged prop
with same numbered prop
by carefully pushing while
supporting the bottom of
motor.
All 4 prop guards should be
used at all times to balance the
Multi-Rotor Hub. If damaged,
gently pull the prop guard off
the Multi-Rotor Hub arm and
replace with the same color
prop guard.
BOTTOM VIEW
C
2
1
C
1
2
3
Publicité
Table des Matières
