Cardin RPQ Mode D'emploi page 18

• Memorizing more transmitters by using a previously memorised transmitter.
This procedure allows you to enable a new transmitter (from a remote position) with the help of a transmitter that has
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
already been memorised in the system. As the presence of the receiver is not required this procedure can be carried out
in any remote location (for example in your chosen sales outlet).
Access to the "rapid memorizing" procedure can be enabled or disabled on the receiver by moving dip 4 of dip-
switch D1. All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
All rights reserved. Unauthorised copying or use of the information contained in
• Dip 4 ON R.MEMO inserted: the rapid memorization procedure is enabled.
• Dip 4 OFF R.MEMO not inserted: the rapid memorization procedure is disabled.
- Remove the upper cover from the transmitter to be memorised and from the transmitter that has already been memo-
rised as shown in the drawing below (det. a).
- Place the transmitter A, that has already been memorised in the receiver, beside the new transmitter B (det. b).
- Using a pointed object press and release the MR button on both transmitter (in sequence or simultaneously).
- The orange LEDS on the transmitters will flash slowly.
- Press and release a channel button on transmitter A that is already present in the receiver (det. c).
- The led of the new unit B will remain lit for 3 seconds to confirm memorization (det. d).
Transmitter B will now command the receiver exactly like transmitter A.
3
1
MR
MR
3
A
B
A
B
2
18