Cardin RPQ Mode D'emploi page 14

Electrical connection (fig. 1)
Before connecting the device to the mains make sure that:
- the voltage and frequency rated on the data plate conform to those of the mains supply;
- an all pole circuit breaker which leaves at least 3 mm between the contacts has been installed
between the device and the mains;
- the wires are fastened down using a cable clamp.
Attention!
- a 6,3A fuse (not supplied with the product) must be wired in series with the 230V power supply.
- only low voltage circuits may be wired to the external circuit binding posts 7...9.
1-2 Power supply 230Vac 50-60Hz
3 Power supply earth connection
4 Motor output (phase 1)
5 Motor output (neutral)
6 Motor output (phase 2)
7 T1 (N.O.) input
8 Common
9 T2 (N.O.) input
L1 Indicator led
P1 Programming button
+
1 2
R1 R2
14
DC0598
3 4
ON
L1
1