When To Change The Thread Lifters; How To Replace The Thread Lifters; Problem Solving Guide; After Sales Service - Miele HS12 Mode D'emploi

When to change the thread lifters

The thread lifters on the suction inlet to
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.
How to replace the thread lifters (dia.
28)
^ Use a suitable screwdriver to remove
the thread lifters from the slots.
^ Fit new thread lifters.
Replacement parts are available from
your Miele Dealer or from Miele (see
end of booklet for contact details).

Problem solving guide

The vacuum cleaner switches off
automatically.
A temperature limiter switches the
vacuum cleaner off automatically if it
gets too hot.
This can occur if, for instance, large
articles block the suction tube or when
the dustbag is full or contains particles
of fine dust. A heavily soiled exhaust or
dust compartment filter can also be the
cause of overheating. Switch the
vacuum cleaner off immediately using
the On/Off foot control s. Disconnect
from the electricity supply. Switch off at
the wall socket and unplug it.
After removing the cause, wait for
approximately 20 - 30 minutes to allow
the vacuum cleaner to cool down. It
can then be switched on again.

After sales service

In the event of a fault that you cannot
easily remedy, please contact
– your Miele Dealer, or
– Miele (see end of booklet for contact
details)
Please note that telephone calls may
be monitored or recored for training
purposes (UK only).

Guarantee

This appliance is guaranteed for 2
years from the date of purchase. In the
UK you must activate your cover by
calling 0845 365 6640 or registering
online at www.miele.co.uk.
For information on the appliance
guarantee specific to your country
please contact Miele. See end of
booklet for contact details.
en
35