Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
This instruction provides for the installation of a Statement or Minimalist
handle collection on a ½" flush inset custom panel.
HANDLE ASSEMBLY
•
Insert stud assembly E from the nonappearance side
of the panel
•
Place the handle caps over the insert stud on the door.
Take care to support the handle so it doesn't fall and
scratch the appliance finish. Make sure both handle
caps are resting on the face of the door.
•
Lock one end of the handle into position by tightening
the countersunk screw D with the Allen wrench
provided. DO NOT over-tighten.
•
Keep supporting the handle as you lock the other end
of the handle into position by tightening the
countersunk screw D. DO NOT over-tighten.
•
Finally tighten the set screw in the handle caps using
the Allen wrench provided in the handle kit
NOTE: Set screw location in end cap will vary by model.
When installing horizontal handles, position the handle
so that the set screws are facing downward.
Installation Instructions
1/4" backer panel
and 0.100" spacer
Stud Insert Assembly-E
D
Allen wrench
provided in
the kit
Insert Assembly E
4
1/2" Wooden door panel
Allen Key provided
with handle kit
31-1000561 Rev. 0
Publicité
Table des Matières
