AudioCodes MediaPack 11 Manuel D'installation Abrégé page 5

Assigning an IP Address to the Device
The default IP address depends on your MP-11x model:
FXS-only models and FXS-with-FXO models: 10.1.10.10

FXO-only models: 10.1.10.11

For all MP-11x models, the default subnet mask is 255.255.0.0 and the Default Gateway IP address is 0.0.0.0.
You can change the IP address using any of the following methods:
Accessing the device's Web-based management interface from a computer using the default IP address

Accessing the device's interactive voice response (IVR) menu, using touch-tone dialing (DTMF tones) on

a standard telephone connected to one of the device's FXS ports
ASSIGNING AN IP ADDRESS THROUGH WEB-BASED MANAGEMENT INTERFACE
Use the device's factory default IP address to initially access the device's Web-based management interface
and then change it to suit your network addressing scheme for subsequent connectivity.
1. Using a crossover RJ-45 Ethernet cable, connect the device's Ethernet port located on the rear panel
and labeled Ethernet, to the LAN port of your computer.
2. Change the IP address of your computer to correspond with the device's default IP address and subnet
mask.
5 | P a g e
EN