Physical Description - AudioCodes MediaPack 11 Manuel D'installation Abrégé

Physical Description

1
[The presence and number of FXS and FXO port interfaces depends on ordered MP-11x model.]
1 100-240V AC power plug entry.
Power LED (located on front panel):
Ready LED (located on front panel):
Fail LED (located on front panel):
2 Ethernet 10/100Base-T Ethernet port (RJ-45) for connecting to the IP network.
Uplink LED (located on front panel):
3 RS-232
RS-232 serial interface port (6-pin mini-DIN female - PS/2).
Note: MP-112 does not provide a serial port.
4 FXS and/or Foreign eXchange Subscriber (FXS) ports (RJ-11) and/or Foreign eXchange Office
FXO (FXO) ports (RJ-11). The number and type of ports depends on ordered MP-11x
model.
Channels Status LED (located on front panel):
5 Reset
Reset pinhole button for resetting the device or restoring it to factory defaults. To
restore the device to factory defaults: Disconnect the Ethernet cable and then
with a paper clip or any other similar pointed object, press and hold down the
button for about six seconds.
2 3
Green On Power received by device
Off No power
Green On Device is powered up
Off Installing software (.cmp file) or device failure
Red On Device failure or initializing
Off Normal operation
Green On Ethernet link established
Green Flashing Data is being received or transmitted
Off No Ethernet link
Green On Phone is in off-hook position
Green Slow-Flashing Phone is ringing
Green Fast-Flashing Malfunction
Off Phone is in on-hook position
2 |
4 5
P a g e
EN
4