Maintenance Procedure; Fixing A Breakdown; Disposal; Customer Service - WHEELBLADES A Mode D'emploi

8 Maintenance procedure

if the ski underside of the Wheelblade becomes too worn over time, it can be replaced. you can
obtain the ski from your point of sale as a sole spare part.
loosen both fastening screws to detach the ski carrier from the ski. put the Wheelblades back
together using the new ski by following the confi guration instructions.
if other parts of your Wheelblade are defective, please contact your point of sale.

9 Fixing a breakdown

The wheel is not clamped properly:
• Ceck the adjustable clamping width (see Chapter 5)
• The parts were not mounted straight during confi guration
• Clear out any items or snow that may have gotten into the indentation of the Wheelblade

10 disposal

Wheelblades that are no longer being used may be broken down into their individual compo-
nents. To break them down, fi rst remove the two fastening screws. The Wheelblades may be
recycled at the usual locations for plastic and metal waste disposal. The type of material of
each individual component is listed under "Setup and Function".
CautiOn!
Cuts! sharp edges
➞ When breaking down into individual components, watch out for sharp
edges from the clamping plate.

11 Customer service

WHeelBlAdeS GmbH
patrick Mayer
info@wheelblades.com
www.wheelblades.com
en 19