Design And Function; Clamping Mechanism; Configuration; Initial Configuration - WHEELBLADES A Mode D'emploi

4 design and Function

4.1 Clamping mechanism

Fig. 4: Clamping mechanism open

5 Configuration

The Wheelblades may only be mounted on the wheels of the front shaft of the wheelchair. They
are designed for wheel diameters of 80 mm to 200 mm and widths of 20 mm to 60 mm.
if the Wheelblades have not yet been adapted to your wheelchair by the manufacturer or sales
representative, you must configure them yourself.

5.1 Initial Configuration

There are 2 scales for setting the clamping width. An outside scale for setting the position of
the ski attachment and the ski and an inside scale for setting the position of the try square
and the ski attachment.
Fig. 5: Position of scales
Outside scale (front and back)
Fig. 6: Definition of scales
50 – 60mm
45mm
40mm
35mm
30mm
25mm
20mm
Referenzmarke
Reference mark on
am Ski
ski attachment
Clamping mechanism closed
inside scale
outside scale
Inside scale (front and back)
Bis 60mm
Up to 60mm
50mm
45mm
40mm
35mm
30mm
25mm
20mm
Referenzmarke
Reference mark on
am Skiaufsatz
ski attachment
en 15