Assembly/Disassembly Instructions; Assembly Instructions; Disassembly Instructions - WHEELBLADES A Mode D'emploi

6 assembly/disassembly instructions

Before initial use, the Wheelblade must be fi tted to the front wheel of your wheelchair. proceed
to Chapter 55 (Confi guration).
danger/risK!
Fall! defects in the Wheelblades may result in a fall.
➞ Check the Wheelblades for damage before each use.
CautiOn!
danger of bruising fi ngers! pinching one's fi ngers between the clamping
bracket and ski/steering wheel of the wheelchair.
➞ do not hold fi ngers between the clamping bracket and ski/steering wheel
of the wheelchair during assembly/disassembly

6.1 Assembly Instructions

1) Check to ensure that the fastening screws are tightened fi rmly to the Wheelblade. Re-
torque them if necessary.
2) ensure that no snow or any other items have gotten into the provided indentation in the
Wheelblade.
3) place the "right" Wheelblade in front of the "right" steering wheel of your wheelchair. Make
sure that the clamping lever is pointing outward (clamping mechanism open) and that
the tip of the ski is facing forward (Wheelblade in direction of travel).
4) place the respective wheel between the try square and the spring plate into the indentation
on the Wheelblade provided for this purpose. The wheel must point to the rear along with
the shaft.
5) When the wheel is positioned in the deepest point of the indentation, fold the clamping
bracket 90° upward until it engages and can no longer be moved.
Fig. 9
6) Check to be sure that the Wheelblade is clamped fi rmly to the wheel.
7) Repeat items 1 through 6 for the second "left" Wheelblade.
danger/risK!
Falling out of the wheelchair/Fall!
due to the shift in weight of the wheelchair user during assembly/disassembly,
the wheelchair may tip over or be put in motion.
➞ Block the wheelchair
➞ Get help from an assistant
danger/risK!
Fall! Faulty assembly/loose screws.
➞ Carry out assembly/basic settings correctly.

6.2 Disassembly Instructions

1) Block the wheelchair.
2) Fold the clamping bracket of the Wheelblades downward (clamping mechanism open).
3) lift the steering wheels out of the Wheelblades.
Fig. 10 Fig. 11
en 17