CyClone SV130 Instructions D'installation Et D'utilisation page 9

VENTILATOR MOUNTING
1. Prepare a round through hole in the outer wall. The hole size is shown in the figure below. While preparing the holes consider the method of laying the
power cable.
A A A -
min 500
Ø170
min 500 Ø170
A
While preparing the hole provide a recess for the cable layout to enable connection of several ventilators in series.
2. Install the telescopic air duct inside the wall, centre the air duct using the mounting plate and seal it with mounting foam.
Inner side of Outer side of
the wall the wall
35 A
Seal the centred
air duct using the
mounting foam
3. Install the mounting plate using the dowels (included in the delivery set).
Lean the mounting box
against the wall and mark Lean the mounting box
Drill the holes and insert the
four holes for dowels
dowels
with screws
SV130 SV150 Installation - English 9