Glass Cooktop - GE JGP636 Instructions D'installation

F
Making the L.P. Conversion
Changing the Cooktop
F3
Burner Orifices:
a. Remove the top grates, burner caps and
burner heads.
MIXER TUBE
BURNER
BOWL
b. Using a 7mm or 9/32" nut driver, remove the
top burner orifices. These may be accessed
through the hole in the cooktop.
NOTE: The orifices have a spring loaded
retaining ring around the
hex head to hold the orifice
in the nut driver during
installation and removal.
A slight amount of force is
required to push the nut
driver down over the ring.
c. Locate the LP/Propane orifices shipped
inside the literature package. They will have
a digit number and the letter "L" on the side.
(IMPORTANT: Save the orifices removed
from the appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II or III), located on the top.
These marks denote the precise location
of each orifice to the cooktop burner.
LP Conversion
BURNER GRATE
BURNER CAP
BURNER HEAD
SPARK IGNITER
MIXER TUBE
(CHIMNEY)
MIXER TUBE (CHIMNEY)
RETAINER
RING

Glass Cooktop

II
II
d. Install the LP/Propane orifices in their
precise locations as noted in the illustration
above.
e. Replace the burner bases, heads, caps and
top grates. (NOTE: When re-attaching the
burner bases to glass top units, tighten
screws to a maximum of 10 in.-lbs torque.)
f. Save the orifices removed from the appliance
for future use.
14
cont.
I
I
III
continued on following page