Uk Declaration Of Conformity - Atlas Copco PFD1500RA-400 Mode D'emploi

Safety Information
Regional Requirements
WARNING
This product can expose you to chemicals including
lead, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For
more information go to

UK DECLARATION OF CONFORMITY

We, Atlas Copco Industrial Technique AB,
SE-105 23 STOCKHOLM SWEDEN, declare
under our sole responsibility that the product
(with name, type and serial number, see front
page) is in conformity with the following UK
Regulation(s):
S.I. 2008/1597
Designated Standards applied:
EN ISO 11148-3
Authorities can request relevant technical information from:
Product Compliance Manager, Atlas Copco Industrial Tech-
nique AB, SE-105 23 Stockholm Sweden
Stockholm, 1 December 2021
Carl von Schantz, Managing Director
Signature of issuer
Authorized Representative UK:
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead, Hertfordshire HP2 7EA
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
product.
Failure to follow all instructions listed below may result
in electric shock, fire, property damage and/or serious
injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
4
www.P65Warnings.ca.gov
© Atlas Copco Industrial Technique AB - 9836 5569 00
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the prod-
uct cease to be legible or become detached, replace with-
out delay.
• The product must only be installed, operated and ser-
viced by qualified personnel in an industrial environ-
ment.
Intended Use
This product is designed for drilling holes, but may be
adapted for other specific purposes using approved acces-
sories. No other use permitted.
Only approved accessories can be used.
Product Specific Instructions
Before drilling operation
WARNING Crushing Hazard
Do not operate the tool if the indexer is not properly
locked! An unlocked tool may cause the complete tool
to rotate and cause severe property damage and bodily
injury.
Make sure that the lock pin is flush to the nut sur-
►
face with a tolerance level of less than 0.3mm above
the surface.
WARNING Crushing Hazard
Keep a safe distance from the tool during operation. A
rotating tool can cause severe bodily injury.
Make sure no body parts are near the tool during op-
►
eration.
Following conditions apply prior to operating the drill:
• Front part locked in the fixture.
• Air hose connects to the drill.
Test the emergency stop button as follows:
1. Push the start button.
2. Push the emergency stop button so that it locks in posi-
tion. The spindle must stop immediately.
3. Pull the emergency stop button to reset it. The motor
must not restart.
4. Disconnect the air hose.
5. Reconnect the air hose.
Perform the following before drilling operation:
1. Lock the tool in the jig.
2. Release the indexer to adjust the position of the tool by
pushing in the button on the indexer.
PFD1500RA-400