Filter Change; Cleaning The Device - Comedes Lavaero 280 Mode D'emploi

Filter change

After some time in operation, the filter elements must be replaced.
Filter removal
1.
•
Always switch and disconnect the device for this purpose.
•
Release the upper lock. The best way to do this is to reach into the left and right
air intakes and press the black control panel/display panel with your thumbs.
•
Now you can remove the filter cover.
•
After removing the pre-filter, the following filter elements can be pulled out of the
unit by means of the lugs provided for this purpose.
The nylon prefilter net can be cleaned under running water and does not need to
2.
be replaced.
Now check the filters. If the HEPA element is not yet too discoloured, vacuum it off
3.
with a vacuum cleaner (preferably outdoors).
If the filters are very dirty or discoloured, replace them.
4.
Please note that the replacement filters must be removed from the protective
5.
film before they can be inserted into the device.
The order of the filters is marked with the numbers 1-3 on the filter flaps, with the
6.
filter 1 located completely outside.
In the last step, replace the filter cover on the air purifier.
7.

Cleaning the device

Disconnect the mains plug before cleaning!
Clean housing:
•
Do not use aggressive cleaning
agents, but only a dry and soft cloth.
Clean air inlet and outlet:
•
Use a vacuum cleaner or a
dry cloth.
(It is best to clean the unit outdoors).
Clean the filter elements:
•
The ventilation effect becomes noticeably weaker, if
•
a lot of dust collects on the filter surface.
Therefore, clean the filters monthly.
•
The nylon pre-filter mesh can be placed under a cold
•
clear water can be washed off.
The pre-filter (1) and the HEPA element (2) can be
•
connected With vacuumed with a vacuum cleaner.
How to remove the filter can be found under "Filter change".
•
Further information on the individual filter elements
•
can be found in the chapter "Further information" at the end of this manual.
•
ENG-9
The filter combination (3) of activated carbon and photocatalysis
filter does not need to be cleaned.
www.comedes.com