Hunter Millennium 9101 Serie Guide De L'utilisateur page 5

opEratIoN
this appliance is for household
use only.
1. place the fan on a dry, safe, flat
surface where it cannot fall or
be pulled by the cord.
2. plug the fan into a grounded
120-volt aC electrical outlet (or-
dinary household current).
do Not use any other type of
outlet. Make sure that the rated
voltage of the fan is the same as
the power source before plug-
ging it into the power source.
3. turn the fan "oN" or "oFF" by
turning the power/Speed Con-
trol knob. the power should al-
ways be oFF before unplugging
the fan.
decorative pieces
(only on 9004X
models)
power/Speed
Control knob
42742-01 04/11/2007
4. to select the speed, turn the
power/Speed Control knob from
oFF to the desired speed set-
ting: o (off ), I (low), II (medium),
III (High).
5. to control the upward and
downward direction of airflow,
loosen the screw on the side of
the fan housing neck. adjust to
the desired angle and tighten
the screw.
6. to make the fan oscillate, push
the oscillation knob down. to
stop oscillating, pull the oscil-
lation knob up. the oscillation
knob is located on the top of the
fan housing, near the handle.
Handle
oscillation knob
FIGurE 3
Motor Housing
up/down adjustment Screw
Base
5