Lcd On/Off - SUPPORTPLUS TouchScreen Manuel De L'utilisateur

5. Press the or key to change length of light time from 5-30 SEC and
5seconds as a step.
6. Press the OK key to save setting and LCD display S u c c e s s f u l
for 2 seconds and exit to current setup state. You can follow the
instruction on the screen to exit from the set up or go to other set-
tings.
SET 3S
TV 010
SUN 11:45
or
Time Setup?
ON 5 SEC
or
D. LCD ON/OFF
If you set "LCD ON/OFF" to "ON" , that means the LCD screen is always
on (it is convenient to see the status but it is bigger power consumption). If you
set up "LCD ON/OFF" to "OFF", the LCD screen will be on for some time and
then be off after any operation on your remote control and you can change the
length of on-time as below steps.
1. Press and hold the "SET" key for more than 3 seconds, then release
it.
2. Press the
the OK key.
3. Press the or key to select the "LCD ON/OFF? ", then press the
OK key.
4. Suppose that you press the or key to change from "ON" to "OFF"
mode, and then press OK key.
Code Setup?
Light ON/OFF?
ON 10 SEC
TV
or key to select the "Configure", and then press
or
Configure
OK
Light?
ON?
DVD
Seccessful
GB
OK
OK
27