Avanti WD361 Manuel D'instructions page 9

Height Adjustment Platform (Model WD363P – ONLY)
To make the water dispenser faucets more accessible your unit has been supplied with a

height adjustment platform. The platform requires assembly as shown below.
Parts Provided:
1 Front Panel
2 Short Screws 2 Long Self-tapping Screws (located in the bag with instruction manual)
Remove all parts from the box and remove the packing materials.
a) Align both the front and back panels of the platform and assemble as shown in
figure 1.
Front Panel
b) Align the assembled platform to the bottom stability ring as shown in figure 2a.
Align the areas marked "1" and "2" on the platform with same areas marked "1"
and "2" on the stability ring.
(NOTE: These areas must be aligned correctly for the unit to be assembled. If the
platform is not aligned correctly to the stability ring, the retaining clips could be
permanently damaged and cause the platform to be unstable).
1 Back Panel 1 Stability Ring (located on the top foam cover)
Fig. 1
Fig 2a
9
Back Panel
Bottom Ring