MOB IT3223 Mode D'emploi page 5

Fig.10.
The corresponding shape symbol flashes when the
fat measurement result displayed
E. Parameter Scope:
NO. Value scope: 1-5groups
Gender: male/female, default male
Age: 10-99 years old, default 20 years old
Weight scope:
Metric system: 10-250KG, default 50KG
Adjust to increase or decrease 0.5KG by each press
U.K.system:22-500LB, fefault110LB
Adjust to increase or decrease 1LB by each press
Height Scope:
Metric system: 90-240CM, default 165CM
Adjust to increase or decrease 1CM by each press
U.K.system:22-95INCH, default60INCH
Adjust to increase or decrease 0.5 INCH by each press
Step Length:
Metric system: 30-180CM, default40CM
Adjust to increase or decrease 1CM by each press
U.K.system:10-72INCH, default40INCH
Adjust to increase or decrease 0.5INCH by each press
F. Metric system/ U.K.system conversion:
Press MODE for3 seconds under fat measurement mode.
3. Step counter mode
A. Press MODE button to enter step counter mode as shown in Fig.11.At this time
accumulated steps are displayed. Please note that the personal NO. selection affects the accuracy of calorie and travel
distance measured (related with the setting of weight and step length). So, please select the corresponding personal NO.
value.
B .Before starting the step count, please press SET button for 2 seconds to reset the exiting record, including the recorded step
number, the calorie value and the travel distance.
Fig.11.
Step counter mode picture
C. Tie the pedometer to the belt and keep it horizontally as shown in Fig.12.The step number will be correspondingly increased by
1 while every time you walk one step. The system will compute the travel distance and calorie value according to the weight
and the step length of the setting group.
Under the step counter mode, press the▲/▼ button to check the dissipated calorie value and the distance you walk as shown
D.
symbol appears. Personal NO .and the