MOB IT3223 Mode D'emploi page 3

4. Appearance specifications
Operational instructions
1. Time and alarm clock setting
A. After switching on, the system enters full screen display(Fig.1)
mode with "BIBI" sound and enters default mode-time mode. In this case,
press the ▲button, the system will change over between the24/12hours systems.
"PM" logo will be displayed when it is in the afternoon in 12 hours system (Fig.2).
Under time mode, press MODE button to enter the alarm clock mode (with ALM mark).Under this mode, press▲ button to
B.
switch on/off the alarm clock.
reminded by the alarm when the alarm is switched on and the alarm will sound continuously for 1 minute or it will be
stopped immediately by pressing any button.
C. Under the time or alarm clock mode, press and hold on SET button for 2 seconds to enter the hour setting mode (the hour
value flashes). Press SET button again to enter minute setting mode (the minute value flashes.)When the digit flashes, it
is press the▲/▼ button to adjust to the value. After setting, press SET button to confirm.
D. Under the alarm clock mode, the system will return to time mode automatically if no button is pressed within 30 seconds.
2. Fat measurement and step counter information setting
Note: The following pictures are used only for reference about the screen display of metric and U.K. system and not for switch
comparison purpose.
A. Under the time mode, press MODE button to enter fat measurement mode as shown in Fig.4. The NO. value flashes.
Fig.4. Fat measurement mode display
At this time ,(1) if you press ▲button, it can change the current displaying personal data group as shown in Fig.5.(2) if you
B.
press the ▼button, exiting value of the height, age, stride will be shown, as shown in Figs.6,7 and 8.
Fig.5.Display the second group information
Symbol will be shown when the alarm is switched on (Fig.3). The user will be