Lanaform Beauty light Mode D'emploi page 6

INSTRUCTIONS FOR USE
EN
HOW TO USE
1. Make sure your skin and neck are clean and dry before starting the facial treatment.
N.B.: To make the treatment more effective, we recommend using your usual anti-ageing cream beforehand.
2. Choose the head you want to use to achieve the desired effect. Hold the handle firmly and push in the head
until you hear a «click». Start by pushing in the top part of the head (see diagram 2).
3. Plug the unit into the mains.
4. Directly place the light in contact with your face, following the instructions below:
We recommend following the treatment below to guarantee optimum results.
During the first eight weeks, use the device for 24 minutes every day: 9 minutes in «pulse» mode and 15 minutes
in «constant» mode. Then use every 2-3 days.
You can successively apply two treatments per day with the two different heads.
Phase 1 : Pulse mode (the light flashes) Phase 1 : Pulse mode (the light flashes) Phase 1 : Pulse mode (the light flashes)
` `
a
1. Divide your face into three sections (diagram a). For convenience, you will use the device successively on these
three sections.
2. Press the Power button and then the «mode» button to select the pulse mode (the light flashes).
3. Start the treatment, successively moving across these three sections:
Neck (diagram b): slide the device from the bottom to the top of your neck using slow circular movements.
Cheeks (diagram c): put the device on the corner of your lips and slide onto your cheek, moving up towards your
ears. Continue up to the top of your cheekbones. Repeat, moving right and left.
Forehead (diagram d): place the device between your eyebrows and slide it upwards. Move the device right and
left.
N.B.: Spend 3 minutes on each section, i.e. a total of 9 minutes.
Phase 2 : Constant mode (the light does not flash) Phase 2 : Constant mode (the light does not flash) Phase 2 : Constant mode (the light does not flash) Phase 2 : Constant mode (the light does not flash)
a
6
c
b
c
b
d
e
d f