Protool MXP 1200 EQ Mode D'emploi page 9

Temperature-dependent overload
protection
To protect the motor from overheating at extreme
permanent load, it is switched off by the protec-
tive electronic system when a critical tempera-
ture is reached.
After a cooling-down period of approx. 3–5 min.,
the machine is again ready for use and can be
fully loaded.
When the machine is warmed by use, the tempe-
rature-dependent overload protection reacts ear-
lier as a result.
Storage
The unit should be stored in a dry place where it
is protected against freezing.
Environmental Protection
Do not open worn out machines and return to the
collection facilities provided for recycling.
Maintenance
G The ventilation slots (3) on the motor casing
should be cleaned out from time to time.
G When the carbon brushes are worn out, the
machine switches itself off. The machine must
then be sent to customer service for mainte-
nance (see enclosed sheet).
G After approx. 100 hours of operation, check
the motor brushes and replace if necessary.
Clean the motor housing.
G After approx. 200 hours of operation, renew
the grease filling in the gearbox.
To verify that the protective insultation
remains intact, the machine must be sub-
jected to a technical safety test afterwards.
For this reason, this work must be per-
formed exlusively by a professional
electro-workshop.
Service
See enclosed sheet.
Guarantee
Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation. In
the EU countries, the warranty period for exclu-
sively private use is 24 months (an invoice or
delivery note is required as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or any
fault acknowledged at the time of purchase, is
not covered by the warranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before being
sent back to the suppliers or to an authorised
PROTOOL customer support workshop. Store
the operating instructions, safety notes, spare
parts list and proof of purchase in a safe place.
In addition, the manufacturer's current warranty
conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as a
result of ongoing research and development work.
Conformity Declaration
We declare to our full responsibility that this
product conform to the following standards or
regulations: EN 60 745-1, EN 55 014-1,
EN 55 014-2, EN 61 000-3-2, EN 61 000-3-3
according to the regulations 89/336/EWG and
98/37/EG.
'