Technical Data; Control Elements; Safety Precautions; Noise/Vibration Information - Protool MXP 1200 EQ Mode D'emploi

Technical Data

Stirrer
Power input
:
1st Gear
2nd Gear
Electronics speed preselection
Two-step switch
Tool mount
Whisk – ∅
Clamp neck – ∅
Weight
Class of protection

Control Elements

1. Switch/regulator
2. Arresting pin
3. Ventilation holes
4. Tool mount
5. Speed selector switch
6. Supplementary handle
7. Flat open-end wrench
8. Whisk (not included in the delivery)
9. Socket
10. Sleeve
11. Mains cable module
Not all of the accessories illustrated or described
are included as standard delivery.

Noise/Vibration Information

Measured values determined according to
EN 50 144.
MXP 1600 EQ / 1602 EQ
Typically the A-weighted sound pressure level of
the tool is 86 dB (A). The noise level when work-
ing can exceed 99 dB (A). Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
MXP 1200 EQ / 1202 EQ
Typically the A-weighted sound pressure level of
the tool is 86 dB (A). The noise level when work-
ing can exceed 99 dB (A). Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
MXP 1600 EQ MXP 1602 EQ
1500 W 1500 W
300–650 rpm 150–300 rpm
— 300–650 rpm
• •
— •
M 14 x 2 M 14 x 2
160 mm 160 mm
57 mm 57 mm
6.4 kg 6.8 kg
II / II /

Safety Precautions

G Observe also other safety directions that are a
part of each instrument delivery.
G Check the flexible lead and plug before each
use of the instrument. Have the faults removed
by an expert.
G The instrument should not be operated in
damp, wet premises; during a rain, fog and
snow in the open, and in environment with a
risk of explosion.
G Before putting the plug in the mains socket the
switch should be in the "off" position.
G Take care of long hair and fashion acces-
sories, work in properly buttoned-up clothes,
without freely flowing parts.
G Secure the vessel with the mixed substance
against moving on the floor.
G Always direct backwards the flexible lead from
the instrument. Flexible lead should not be
exerted by tensile stress and should not lie on
or pass over sharp edges.
G Take care that you take a safe and firm stand
2 .
at work.
G Use the supplementary handle (6).
G Consider possible reaction torque.
2
.
MXP 1200 EQ MXP 1202 EQ
1200 W 1200 W
300–650 rpm 150–300 rpm
— 300–650 rpm
• •
— •
M 14 x 2 M 14 x 2
140 mm 140 mm
57 mm 57 mm
5.7 kg 6.1 kg
II / II /
Safe work with the instrument is
only possible after you read
thoroughly this manual for use and
maintenance and observe precisely
the here specified instructions.
GB